These cooling towers are designed and manufactured for maximum service life, dependability and performance. They are readily adaptable for any type of water cooling application.

The selection of material for the cooling tower is based on the requirement that they must be completely resistant to corrosion and chemicals. This has been achieved through the exclusive use of FRP, PVC and MSHDG / SS supporting structure.

Design Specifications :

“VARUN” cross flow cooling tower operates according to cross flow principle. The hot water is fed in to a FRP splash box, having target nozzles in the bottom to equally distribute water over PVC perforated ‘V’ bar fill. By evaporation and direct contact the water transfers heat to the air, which is sucked in by propeller type fan. The cold water is collected in a basin at the bottom of the tower for re-circulation.

Casing :

Casting is made of tough FRP panels and has sufficient structural strength to withstand high wind velocities and vibrations.

Fills and Drift Eliminator :

PVC Perforated ‘V’ Bar type fill is supplied, to provide maximum watted surface, longer air water contact and more efficient water cooling. Drift Eliminators are made of PVC and positioned between fill and fan cylinder.

Water Distribution System :

Hot water distribution splash box is open gravity type, will be made of FRP with HDPE gravity target nozzles.

Basin :